Subwoofers are best left switched on and fully active during set up if such a processor is used. Standby: With the switch set to Standby the subwoofer will become active when 12V is applied to the Trigger Input (Item 10 in Figure 1). Zero volts at the input will return the subwoofer to sleep. Assistance on hooking up a B&W ASW610 subwoofer. Good day, We recently bought a Yamaha RX-V6A AV receiver, in combination with 5 Bowers & Wilkins M1 speakers and an ASW610 subwoofer. The speakers are connected via speaker cables laid in the wall. However, we are scratching our heads a bit with the subwoofer connection. For the best low-frequency integration with your room, try placing the subwoofer where you would normally sit, then connecting it to your amp, disconnecting your other speakers (at the amp end) and turning it on. Then play a piece of music that has a consistent bass beat, and walk around the boundaries of your room, listening to the bass as you go. Further simplifying its offerings, Bowers & Wilkins’ recent revamp of the entry-level 600 Series has pared the line down to the 603 tower ($1,800/pair), the HTM6 center channel ($599), and the 606 and 607 bookshelf speakers ($800 and $600/pair, respectively) along with three subwoofers that carry over from the previous 600 Series. The M-1 speakers will run you $250 a pop and the PV1D sub another $1700. For the B&W name, a sub-$3000 5.1 system is pretty reasonable. If you are looking for small speakers, not because you can't afford larger ones, but because you don't have the space, these should definitely be on your list. Today we check out the Bowers and Wilkins DB3D Subwoofer. Is it better than the Kef KF92 or the SVS SB3000?BUY HERE: speaker that comes through my house can accommodate a bi-wire connection, so I’ve simply stuck with single-wire speaker connections. He immediately told me that I hadn’t truly heard my beloved 800s then, because all Bowers & Wilkins speakers, especially their larger floor-standing models, benefit from bi-wiring. The parallels between Bowers & Wilkins' flagship 800 Series Diamond loudspeakers and its DB2D subwoofer are more than skin deep. The 16.9 x 14.8 x 14.2-inch (HWD) sub uses the same 10-inch Aerofoil cone drivers found in the acclaimed Diamond range and touts some of the same leading-edge architecture and materials. Vay Nhanh Fast Money.

bowers and wilkins subwoofer setup